Von Hunter

From Kustomrama
Jump to: navigation, search
Von Hunter's 1957 Plymouth. The car was restyled in the late 1950s.
Bill Hoffman's 1953 Chevrolet Bel Air was restyled by Von Hunter and George Schultz at Wilkenson's Body Shop in the late 1950s.
Bill Schott's 1956 Chevrolet Corvette of Portland, Oregon. Bill was a member of The Kings of Portland car club, and his Corvette was mildly restyled by Von Hunter in 1960.
Bill Schott's 1957 Ford Fairlane 500 of Portland, Oregon. Bill was a member of The Kings of Portland car club, and his Fairlane was mildly restyled by Von Hunter in 1961. By then, Von Hunter had opened up his own shop in Portland.
Ron Sweeney's 1957 Ford was restyled by Von Hunter in 1962. The car became known as "Seaburst."
Von Hunter's 1960 Chevrolet Corvette. The car was restyled in the early 1960s.
Von Hunter's 1960 Chevrolet Corvette was featured on the cover of Car Craft September 1963. According to the story, Von Hunter put forth two years of his spare time efforts in creating the violent violet custom with metalflake paint. George Barris snapped the photos that were used in the story.
A photo of Von Hunter with the Corvette from the Car Craft September 1963 story. Photo by George Barris, courtesy of Car Craft Magazine.
A photo of Von next to his 1957 Chevrolet Corvette custom. Starting with a crashed car, the build was completed sometime around 1967.

Von Hunter of Portland, Oregon. Von Hunter is a recognized Oregon custom car builder.


Wilkenson's Body Shop

In the late 1950s Von worked at Wilkenson’s Body Shop. Ron Gerlitz grew up in the area, and he met Von when he worked for Wilkenson. "I was 16," Gerlitz told Sondre Kvipt of Kustomrama in 2020, "and I had a '49 Chevy. My dad told me don't you be changing anything on that car. First thing I did was to put a '58 Impala steering wheel on it." After the swap, the Impala wheel ended right up in his face. Wilkenson Automotive was about four blocks from Ron's house so he went up there. Von asked Ron what he could do for him. Ron showed him the car, and Von told him he could cut the column for 25 dollars. "That's how I met him. After about three hours he had cut the column and put my steering wheel down where it belonged."[1]


Own shop

Later on, Von teamed up with custom painter Phil Shaffer, and they opened up a shop across from Ron's high school. "I used to skip school a lot," Ron told Kustomrama, "about one day a week I used to go over there and sit. One day he said, "Shouldn't you be in school?" I said, "Well, I am in school." He said, "What do you mean?" I said, "I'm learning more over here watching you." Ron recalled that Von was a great guy. Great and very talented. "He could do stuff and never use any bondo. It was unreal how he could stretch and form metal just by hands and a couple of tools." Ron recalled Von and Phil doing mostly custom work in their shop. "Von would rather do custom work than take a wreck in." Ron and his buddies, who were 17 and 18 years old all had cars with some custom work done to them, and Von was their go-to man. "We hung out at his shop quite a bit." Ron had a 50 Chevy that Von put 1950 Buick taillights on, rounded the hood corners on, and louvered the hood on. "He was one of those guys you could go in and talk to, and after about 10 minutes you felt like you had known him forever. And with him it wasn't like bring it back in six months, or bring it back in a week, it was usually like "What are you doing tomorrow? Stop by, and we can probably take care of that tomorrow for you." Ron went to him for years for lowering cars. "They had a thing on Saturdays. For, I think it was 20 dollars, he would lower the front and back of your car for 20 bucks. It would take him about 15 to 20 minutes. You would come in looking like a four-wheel-drive and go out real low."[1]


Von Hunter's 1960 Chevrolet Corvette

In 1963 Von Hunter's 1960 Chevrolet Corvette was featured on the cover of Car Craft September 1963. According to the featured story inside, Von Hunter had over 16 years of experience when it came to customizing cars. At the time he was running his own shop. Bob Holbert and Phil Shaffer where two employees that worked with Hunter when the Corvette was built.[2]


Teaching

Von ended up as a school teacher at Benson Polytech in Portland in the late 1980s or the early 1990s. "He went in there and became the body and fender teacher," Ron Gerlitz recalled. "He did that until he retired, working with cars on the side."[1]


Von Hunter's Cars

Von Hunter's 1957 Chevrolet Corvette
Von Hunter's 1957 Plymouth
Von Hunter's 1960 Chevrolet Corvette


Cars Restyled by Von Hunter

Ron Gerlitz's 1950 Chevrolet
Bill Hoffman's 1953 Chevrolet Bel Air
Bill Schott's 1956 Chevrolet Corvette
Bill Schott's 1957 Ford Fairlane 500
John W. Peterson's 1957 Ford Thunderbird
Ron Sweeney's 1957 Ford - Seaburst
Dale Drake's 1959 Chevrolet Corvette


References




 

Did you enjoy this article?

Kustomrama is an encyclopedia dedicated to preserve, share and protect traditional hot rod and custom car history from all over the world.




Can you help us make this article better?

Please get in touch with us at mail@kustomrama.com if you have additional information or photos to share about Von Hunter.


This article was made possible by:

SunTec Auto Glass - Auto Glass Services on Vintage and Classic Cars
Finding a replacement windshield, back or side glass can be a difficult task when restoring your vintage or custom classic car. It doesn't have to be though now with auto glass specialist companies like www.suntecautoglass.com. They can source OEM or OEM-equivalent glass for older makes/models; which will ensure a proper fit every time. Check them out for more details!

Do you want to see your company here? Click here for more info about how you can advertise your business on Kustomrama.


Personal tools
Help us
facebook